The Lil'SQuiRT™ V2 was derived from our SQuiRT™ S400 outdoor trainer. The Lil'SQuiRT™ features many of the design characteristics you loved about the SQuiRT™ wrapped in a gymnasium friendly package. The removable wing rubber-bands in place making it less likely to damage when crashed. The landing gear is mounted with a shock absorbing mount to smooth over those less-than-perfect landings. The large undercambered wing encourages slow flight so there is plenty of time for the new pilot to react! Designed with the beginner in mind. The Lil'SQuiRT™ introduces the new hobbyist to working with balsa, covering, and control setup in a non-threatening manner. Beginners will appreciate this affordable design, simple single surface wing, low parts count, and self jigging fuselage that builds straight every time. The gentle handling Lil'SQuiRT™ will not spin and stalls are always clean, predictable, and straight ahead. Slow speed, wide flight envelope, and forgiving handling keeps the new pilot from trouble and the low mass, durable, all balsa construction makes encounters with the ground a non-event. Should you find your Lil'SQuiRT™ requires repair; damage is easily fixed at the field in seconds with thin CA glue. Advanced pilots will enjoy relaxing low and close in flying encounters with their Lil'SQuiRT™ V2. The Lil'SQuiRT™ V2's retro old-timer design echoes fond memories of childhood free flight models. The clean lines, small size, and flight characteristics will garner all sorts of attention wherever you and your Lil'SQuiRT go! Enter the world of RC Micro / Indoor flight with conventional electronics and radio gear. The high quality, affordable, RC system used in the Lil'SQuiRT is easily transported to more advanced models, micro and parkfliers, as your skills develop. Stevens AeroModel offers indoor/backyard pylon and aerobatic models that make extensive use of the Lil'SQuiRT's flight pack so you won't have to purchase your electronics all over again when you are ready to move on. Kit includes full size rolled plans, push rods, landing gear, nylon spoked wheels, and motor mount. See our list of suggested products for completing your Lil'SQuiRT™ at the bottom of this page. Trexler #2 Tires as pictured on model above are sold separately. Pre-Cut vinyl windscreen decal is available as an option.
Trexler size 2 pneumatic latex balloon wheels. Product Inflates 1-1/2 to 1-5/8 in. diameter, sold in pairs, and are suitable for free flight and light weight models with a maximum airframe weight of 6 oz. Made right here in U.S.A. just like they always have been!
Trexler do's and don'ts:
DO NOT - Inflate using your mounth. Moisture from your lungs/mouth will cause the valve stem to seal rendering the product useless.
DO NOT - Leave inflated while in storage, again the valve stem may seal due to moisture within the tire.
DO NOT - Over-inflate tire with pump as tire will rupture or blister. Trexler wheels (#1-#6) are best inflated using a glue syringe.
DO NOT - Disount tire from wooden hub as you might damage or puncture the tire.
DO NOT - Use on models heavier than specified by Trexler.
DO - Store in a cool, dry, dark place.
DO - Inflate tires prior to use using the Trexler inflator or large capacity syringe.
DO - Deflate tire after each flying session and leave the valve stems open.
DO - Adhere to the suggested carrying capacity of the tires when sizing to fit your model.